⒈The ICF molding machine chooses a flat table, and the machine is stable, and the chassis feet can be pulled apart to make the machine panel easy to observe.
⒉Insert the plug on the hand-held sensor head into the socket on the panel and tighten it. Pay attention to the positioning gap
⒊Insert one end of the power cord into the socket on the rear panel of the chassis, and insert the other end into the power supply socket. Be sure to use a single-phase three-wire power supply.
⒋Turn on the "POWER SW." on the rear panel of the chassis, press the "SWITCHING" button on the panel, and wait for the "WARM UP" green indicator light to turn on, and the machine can work.
⒌Press and hold the "SETTING BUTTON" button and set it to an appropriate value, generally between 0.5-2.0 seconds.
⒍Place the induction head on the lid of the ICF forming machine, and press the start button on the handle. At this time, the "HEATING" red indicator light is on, indicating that it is heating, and the induction head should not be removed, and the "HEATING" is red. After the indicator light is off, remove the sensor head, and wait for the "WARM UP" green indicator light to turn on or the buzzer in the machine to make a short "beep" prompt, and then the next container can be sealed.
⒎Check the sealing quality, according to different materials, diameter containers and production efficiency, properly trim the "SETTING BUTTON" button to make the sealing quality the best.