Coordinate table for EPS foam cutting machine
The coordinate workbench is mainly composed of upper carriage, middle carriage, lower carriage, lead screw, gear box and other components. The longitudinal and lateral movement of the carriage adopts a V-flat rolling guide rail structure. The coordinate table is used to install and drive the workpiece to move in X and Y directions in the plane of the table. The coordinate table is divided into upper and lower layers, which are respectively connected with the X-axis and Y-axis screw. Movement in two directions is realized by two stepping motors through two pairs of anti-backlash gears and screw rotation. Every time the stepper motor receives a pulse signal from the microcomputer, its output shaft rotates a step angle. The lead screw is driven to rotate through the speed change of the anti-backlash gear, so that the table moves 0.001 mm correspondingly. The effective stroke of the coordinate table is the moving distance corresponding to the rotation of the screw driven by the stepping motor. The front end of the screw of EPS foam cutting machine adopts two angular contact bearings to eliminate the gap, and the pre-tightening force can be adjusted to make the gap close to zero. It has the advantages of flexible rotation, high precision and long service life, so it is widely used. Since the control system adopts open-loop control, the machining accuracy of the machine tool is mainly determined by the motion accuracy of the coordinate table.
EPS foam cutting machine precautions and coordinate workbench
Nowadays, society is progressing, technology is developing, and many new products have begun to emerge. EPS foam cutting machine is one of them, literally, it is used to cut things. Does anyone know the coordinate table of the EPS foam cutting machine? Many products in the machinery industry are a little dangerous when used. Let's take a look together.
Precautions for EPS foam cutting machine
1. Before starting the machine, check whether there is any air leakage in the pipeline of the machine, and never start the machine if there is any air leakage.
2. Pay attention to the command and coordination of technicians when maintaining the CNC cutting machine.
3. Close all air valves before shutting down, and release the remaining gas in the air circuit.
4. The working raw materials used by the cutting machine are flammable gases such as acetylene, propane, liquefied petroleum gas and other gases. Therefore, it is necessary to regularly check whether the entire gas circuit is sealed.
5. The operator should control it in time when adjusting the fire to avoid fire.
6. The air source part of the cutting machine should be kept away from open flames, and carbon dioxide or other corresponding fire extinguishing devices with normal functions should be placed around it.
7. In case of emergency during operation, immediately press the red emergency stop switch to prevent accidents. It is mainly used for cutting foam materials. It can cut rigid foam, soft foam, and plastic into squares, rectangles, strips, etc. It has the advantages of high cutting efficiency, accurate cutting size, and high precision.
EPS foam line cutting machine is mainly used for cutting foam materials. It can cut hard foam, soft foam, and plastic into squares, rectangles, strips, etc. It has the advantages of high cutting efficiency, accurate cutting size, and high precision.